How to change the vacuum pump oil

At Safaripack, we not only provide high-quality silicone seals and gaskets for vacuum sealers, but we also want to ensure that you have all the information you need to maintain and optimize your vacuum sealer's performance. One important maintenance task is changing the vacuum pump oil. Follow the steps below to properly change the oil in your vacuum pump.

Step 1: Gather the necessary materials

Before you begin, make sure you have the following materials:

• New vacuum pump oil
• Oil drain pan
• Wrench or socket set
• Clean cloth or paper towels

Step 2: Prepare the vacuum pump

Ensure that the vacuum pump is turned off and unplugged from the power source. This will prevent any accidents or injuries during the oil change process.

Step 3: Locate the oil drain plug

Refer to your vacuum pump's user manual or manufacturer's instructions to locate the oil drain plug. It is usually located at the bottom of the pump.

Step 4: Drain the old oil

Place the oil drain pan underneath the oil drain plug to catch the old oil. Use a wrench or socket set to loosen and remove the oil drain plug. Allow the old oil to completely drain into the pan.

Step 5: Clean the oil drain plug

While the old oil is draining, take the opportunity to clean the oil drain plug. Use a clean cloth or paper towels to wipe away any dirt or debris from the plug.

Step 6: Replace the oil drain plug

Once the old oil has finished draining, securely tighten the oil drain plug back into place. Ensure that it is properly sealed to prevent any oil leaks.

Step 7: Add new vacuum pump oil

Refer to your vacuum pump's user manual or manufacturer's instructions to determine the appropriate type and amount of oil to use. Carefully pour the new oil into the oil fill port of the vacuum pump. Be cautious not to overfill.

Step 8: Check the oil level

After adding the new oil, check the oil level using the oil level sight glass or dipstick, if applicable. The oil level should be within the recommended range indicated by the manufacturer.

Step 9: Dispose of the old oil properly

Dispose of the old oil in accordance with local regulations. Do not pour it down the drain or throw it in the trash. Contact your local waste management facility for proper disposal methods.

Step 10: Test the vacuum pump

Once you have completed the oil change, plug in the vacuum pump and turn it on to ensure that it is functioning properly. Listen for any unusual noises or vibrations.

By following these steps, you can effectively change the vacuum pump oil and maintain the performance and longevity of your vacuum sealer. If you have any further questions or need assistance, please don't hesitate to contact us at Safaripack. We are here to help!